Allow user to select cpu undervolt
There have been quite a few issues across the SANSA AMS line related
to CPU undervolting while most players show greatly increased runtime
some crash.
Rather than constanly upping the voltage we now have a
setting with a safe value for all players and the option for lower voltages
I plan to add a few other options here later such as disk
timings and maybe some other clocks/experimental settings
Added: Disk Low speed option for AS3525v2 devices cuts
frequency to 12 MHz from 24 MHz
Added: Disk Low speed option for AS3525v1 devices cuts
frequency to 15.5 MHz from 31 MHz
Added: I2c Low Speed AS3525 devices, should be bigger improvement for v1 devices
Fixed: Debug menu for AS3525v2 No SDSLOT frequency,
Showed IDE freq though it is unused
Added: DBOP and SSP underclocking affects display on v1/v2 respectively
Fixed: debug menu now has SSP frequency, and SSP_CPSR
Update: made settings menu more generic
Update: cleaned up code
Added: Clip v1 & Fuze v1 didn't have HAVE_ADJUSTABLE_CPU_VOLTAGE.
not sure why but, waiting on testing to confirm
Added: C200v2 and E200v2 devices and HAVE_ADJUSTABLE_CPU_VOLTAGE.
Fixed: v1 devices don't like display timing set lower (dbop)
v1 devices don't have a divider set for ssp (causes divide by 0)
Fixed: ClipZip display lags with Max SSP divider changed from 0xFE to 0x32
Fixed: v1 devices didn't work properly with highspeed sd cards
Added code from http://gerrit.rockbox.org/r/#/c/1704/
Added powersave and IDE interface enable/disable
Added: V2 devices now have powersave enabled on sd interface
Update: cleaned up code, lang defines, added manual entries
Update ssp clock mechanism added calculated ssp divider to clipzip
Update turn display clock off when clip+ turns off display
Fixed: clipzip wrong register for SSP clock
Change-Id: I04137682243be92f0f8d8bf1cfa54fbb1965559b
TODO: add other players?
Saves 100+ bytes (50 of it in iram), saves a bit of power
Internal LCD clock decreased but with added efficiency of drawing routines
loses only around 2 Hz on the scanrate (~75Hz) while fps is slightly increased
Column offsets are now calculated outside the loops saving a few instructions
Passing a LCD_NOP command after lcd_update turns off Data/Cmd# gpio
saving a bit more power
Added a function lcd_write_cmd_triple() that allows 3 commands to be sent at once
when enabled with LCD_USE_FIFO_FOR_COMMANDS it sends them back to back without
checking FIFO status in between or sending to thhe D/C# Gpio.
Makes an assumption about the FIFO being large enough to
accept 3 commands after being emptied which should be the case on the
clipv1, clipv2, clipplus. I have only enabled it for the clip plus
as thats the only device I have to test it on.
On clip+ the SSP clock is now turned off when screen is off
Change-Id: Ib5fd24697bfe4ac8b8ee017361e789e4a7910d21
The new controller framebuffer (different from what is in clipv1/clipv2 and some clip+) has 128 columns, the old has 132 columns and is centered on the screen.
git-svn-id: svn://svn.rockbox.org/rockbox/trunk@27257 a1c6a512-1295-4272-9138-f99709370657
