ErosQNative: Set extra ES9018K2M options

Set number of FSR edges required for DPLL/ASRC lock
Set DPLL bandwidth larger

Both should help prevent dropouts, especially with
sample rates >=96khz

Credit to ZappBranigan2972 on the forums

Change-Id: I55a90d44ac7fcec5894377e32cdadad66bb05610

firmware/target/mips/ingenic_x1000/erosqnative/audiohw-erosqnative.c

@@ -104,6 +104,30 @@ void audiohw_postinit(void)
         * for 24-bit data... */
         // es9018k2m_write_reg(ES9018K2M_REG1_INPUT_CONFIG, 0b01001100); // 24-bit data
 
+       /* Datasheet: Sets the number os FSR edges that must occur before    *
+        * the DPLL and ASRC can lock on to the the incoming Signal.         *
+        * When Samplerates >= 96khz could be used, STOP_DIV should be set   *
+        * to 0 (= 16384 FSR Edges).                                         *
+        *   Reg #10 [3:0] (0x05 default, 2730 FSR Edges)                    */
+        es9018k2m_write_reg(ES9018K2M_REG10_MASTER_MODE_CTRL, 0x00);
+
+       /* Datasheet: The ES90x8Q2M/K2M contains a Jitter Eliminator block,   *
+        * which employs the use of a digital phase locked loop (DPLL) to     *
+        * lock to the incoming audio clock rate. When in I2S or SPDIF mode,  *
+        * the DPLL will lock to the frame clock (1 x fs). However, when in   *
+        * DSD mode, the DPLL has no frame clock information, and must in-    *
+        * stead lock to the bit clock rate (BCK). For this reason, there are *
+        * two bandwidth settings for the DPLL.                               *
+           Reg #12 [7:4] (0x05 default) bandwidth for I2S / SPDIF mode.
+           Reg #12 [3:0] (0x0A default) bandwidth for DSD mode.
+        * The DPLL bandwidth sets how quickly the DPLL can adjust its intern *
+        * representation of the audio clock. The higher the jitter or        *
+        * frequency drift on the audio clock, the higher the bandwidth must  *
+        * be so that the DPLL can react.                                     *
+        * ! If the bandwidth is “too low”, the DPLL will loose lock and you  *
+        * ! will hear random dropouts. (Fixed my SurfansF20 v3.2 dropouts)   */
+        es9018k2m_write_reg(ES9018K2M_REG12_DPLL_SETTINGS, 0xda);
+
     } else { /* Default to SWVOL for PCM5102A DAC */
         logf("Default to SWVOL: ret=%d", ret);
     }