// Setup for the ESP32 S3 with ILI9341 display
// Note SPI DMA with ESP32 S3 is not currently supported
#define USER_SETUP_ID 70
// See SetupX_Template.h for all options available
#define ILI9341_DRIVER

// Typical board default pins - change to match your board
// #define TFT_CS   34 //     10 or 34 (FSPI CS0)
// #define TFT_MOSI 35 //     11 or 35 (FSPI D)
// #define TFT_SCLK 36 //     12 or 36 (FSPI CLK)
// #define TFT_MISO 37 //     13 or 37 (FSPI Q)

// // Use pins in range 0-31
// #define TFT_DC    7
// #define TFT_RST   6

#define TFT_MISO 37
#define TFT_MOSI 35
#define TFT_SCLK 36
#define TFT_CS 6 // Chip select control pin
#define TFT_DC 5 // Data Command control pin
// #define TFT_RST 4  // Reset pin (could connect to RST pin)
#define TFT_RST 9 // Set TFT_RST to -1 if display RESET is connected to
// ESP32 board RST

//#define TOUCH_CS 16 // Optional for touch screen

#define LOAD_GLCD
#define LOAD_FONT2
#define LOAD_FONT4
#define LOAD_FONT6
#define LOAD_FONT7
#define LOAD_FONT8
#define LOAD_GFXFF

#define SMOOTH_FONT

// FSPI port (SPI2) used unless following defined. HSPI port (SPI3) NOT TESTED
// YET
//#define USE_HSPI_PORT

//#define SPI_FREQUENCY  27000000
#define SPI_FREQUENCY 40000000 // Maximum for ILI9341

#define SPI_READ_FREQUENCY                                                     \
  6000000 // 6 MHz is the maximum SPI read speed for the ST7789V

#define SPI_TOUCH_FREQUENCY 2500000