Use AXP2101's egauge battery percent level if available (hw4 units).
If not available (_battery_level() will return -1 on hw1-hw3 units),
fall back to voltage battery level.
Also fix logic in axp2101_battery_status()
Change-Id: Ic300418532dae6f7772fff8bf5e2b32516f3b973
Improve ADC behavior, add correct conversion
for die temperature, add readout of EGauge to debug screen.
Add delay to give ADC time to get a good reading. Initial reading
may still be 1-3% optimistic, which is probably ok.
EGauge appears to be pretty good, but no great need to convert
to using it either.
Change-Id: Iab9d50e2427f656ad0875f9a623b03545fc69881
Support hw4 units with AXP2101 PMU
Bootloader successfully compiles and loads onto device.
The LCD appears to be identical to hw3 units.
Scroll wheel and buttons work
Audio output works, including volume.
HP/LO detect works
Rockbox build is generic
GPIO gating logic seems to be working as intended now.
- Added new GPIO definitions - some significant overlaps with pins
from previous hardware revisions...
- Added some GPIO definitions for older players we didn't know about
- Add register definitions for AXP2101 from datasheet
(these are very different from AXP192!)
- Add AXP2101 regulator definitions, need to support multiple step
sizes per regulator.
- Verify AXP2101 voltage set multi-range logic
- Verify AXP2101 voltage get multi-range logic
- Make AXP2101 its own driver
- AXP2101 driver should be "minimally viable", though I think
there is some extra functionality that could be implemented.
- Disabling the coulomb counter stuff - we could maybe make
the E-Gauge work for the same purpose, but it only appears to
be used on the debug screen at the moment so it doesn't seem
like it's worth the effort.
- Found new button GPIOs
- Found error in my GPIO setting logic, blue light works now!
- Set LDO/DCDC output voltages to OF's settings, as far as
I can tell.
- Determined we probably want TCS1421_CFG1:0 to be 0x00,
for UFP behavior
- Tested this rb build with both old and new bootloaders on hw1.5,
hw2, hw4 in as many configurations as I can think of, works across
the board.
- Bootloader can install itself on hw4, so nand chip isn't novel
- Uninstallation file can be made by patcher script, works on hw4
- Installation file can be made by patcher script, works on hw4
- Added HW4 to rbutil, manual
Change-Id: I5b75782273e81c2c6f2b9c79501c8b7cbf88391f
